SMART 3D Multimaterial Dryer
Low moisture for high performance
Are you familiar with these printing failures?

Jams

Soft or Brittle Parts

Bad Surface Finish

Bad Extrusion Flow

Stringing
Heat-based solutions cannot deal with moisture effectively

Time
Drying cycles are typically 8-48 hours long

Quantity
These solutions cannot process more than a few pounds of material

Moisture Rate
Achieving a relative humidity of less than 10-30% (depending on the material) is hard or even impossible with such techniques

Versatility
Materials with different thermal properties may not be dried simultaneously

Performance
Since this method depends on contact with dry air, moisture may be found even after a full drying cycle

Cost
Up-to 10 times more energy efficient than heat-based solutions
The Smart3D Multimaterial Dryer is the only current solution that integrates our Hybrid Drying Technology™ at the end-user level

Preserve the Properties of your material
Our Hybrid Drying Technology™ dries your filament and preserves its properties, ensuring your material is in its best conditions to be printed.
- ✒ Dry over 10 times faster
- ✒ Dry up to 20 spools
- ✒ Store your dry filament
- ✒ Achieve perfectly dry filament